Een MTS schroefset met Eibach veren, geschikt voor de BMW 5 serie E34 Touring E34 518i / 520i / 525i / 530i / 540i / 525td / 525tds / M5
Street variant
De ophanging van de Street-serie is de standaardconfiguratie van MTS Technik-ingenieurs, het garandeert een breed scala aan verlagingen en een balans tussen comfort en stijfheid.
Verlaging voorzijde: van 20 tot 95 mm
Verlaging achterzijde: van 20 tot 85 mm
Maximaal belasting (voor):1060 kg
Maximaal belasting (achter):1300 kg
Geschikt voor:01/88 - 03/97
Let op:
Front and rear axle height adjustable (threaded shock absorber housing).
Not for 4x4.
Only for vehicles without NIVO / factory pneumatic suspension.
If the vehicle is equipped with a stock sport suspension, the lowering mentioned in this catalogue will be relatively lower.
During the installation of suspension set the clearance between tire/rim and suspension strut shall be checked. The minimum allowed gap is 5mm (0,2 inch). Otherwise use certificated wheel spacers.
Independent height adjustment at the lower brackets on the front dampers.
Set includes 2x upper "camber plates" on the front axle.
The installation requires the use of OE front struts - they should be cut and welded as described in the attached manual.
strut diameter at the front axle of 55 mm
Een MTS schroefset met Eibach veren, geschikt voor de BMW 5 serie E34 Touring E34 518i / 520i / 525i / 530i / 540i / 525td / 525tds / M5
Street variant
De ophanging van de Street-serie is de standaardconfiguratie van MTS Technik-ingenieurs, het garandeert een breed scala aan verlagingen en een balans tussen comfort en stijfheid.
Verlaging voorzijde: van 20 tot 95 mm
Verlaging achterzijde: van 20 tot 85 mm
Maximaal belasting (voor):1060 kg
Maximaal belasting (achter):1300 kg
Geschikt voor:01/88 - 03/97
Let op:
Front and rear axle height adjustable (threaded shock absorber housing).
Not for 4x4.
Only for vehicles without NIVO / factory pneumatic suspension.
If the vehicle is equipped with a stock sport suspension, the lowering mentioned in this catalogue will be relatively lower.
During the installation of suspension set the clearance between tire/rim and suspension strut shall be checked. The minimum allowed gap is 5mm (0,2 inch). Otherwise use certificated wheel spacers.
Independent height adjustment at the lower brackets on the front dampers.
Set includes 2x upper "camber plates" on the front axle.
The installation requires the use of OE front struts - they should be cut and welded as described in the attached manual.
strut diameter at the front axle of 55 mm
