Een MTS schroefset met Eibach veren, geschikt voor de BMW 3 serie E93 Cabriolet E93 318i / 320i / 323i / 325i / 330i / 335i / 320d / 325d / 330d
Street variant
De ophanging van de Street-serie is de standaardconfiguratie van MTS Technik-ingenieurs, het garandeert een breed scala aan verlagingen en een balans tussen comfort en stijfheid.
Verlaging voorzijde: van 20 tot 55 mm
Verlaging achterzijde: van 30 tot 65 mm
Maximaal belasting (voor):1090 kg
Maximaal belasting (achter):1200 kg
Geschikt voor:08/06 - 12/13
Let op:
Front and rear axle height adjustable (threaded shock absorber housing on the front, dampers, springs and height adjustable elements on the rear).
Not for 4x4.
Only for vehicles without NIVO / factory pneumatic suspension.
If the vehicle is equipped with a stock sport suspension, the lowering mentioned in this catalogue will be relatively lower.
During the installation of suspension set the clearance between tire/rim and suspension strut shall be checked. The minimum allowed gap is 5mm (0,2 inch). Otherwise use certificated wheel spacers.
In some cases additional OE-parts for the installation of the suspension components are required. Those are not included in the set.
Including M-Technik.
Een MTS schroefset met Eibach veren, geschikt voor de BMW 3 serie E93 Cabriolet E93 318i / 320i / 323i / 325i / 330i / 335i / 320d / 325d / 330d
Street variant
De ophanging van de Street-serie is de standaardconfiguratie van MTS Technik-ingenieurs, het garandeert een breed scala aan verlagingen en een balans tussen comfort en stijfheid.
Verlaging voorzijde: van 20 tot 55 mm
Verlaging achterzijde: van 30 tot 65 mm
Maximaal belasting (voor):1090 kg
Maximaal belasting (achter):1200 kg
Geschikt voor:08/06 - 12/13
Let op:
Front and rear axle height adjustable (threaded shock absorber housing on the front, dampers, springs and height adjustable elements on the rear).
Not for 4x4.
Only for vehicles without NIVO / factory pneumatic suspension.
If the vehicle is equipped with a stock sport suspension, the lowering mentioned in this catalogue will be relatively lower.
During the installation of suspension set the clearance between tire/rim and suspension strut shall be checked. The minimum allowed gap is 5mm (0,2 inch). Otherwise use certificated wheel spacers.
In some cases additional OE-parts for the installation of the suspension components are required. Those are not included in the set.
Including M-Technik.
